1/14

Fraction1/14
Decimal≈ 0.0714285714exactly 0.0(714285)
Percent≈ 7.142857%exactly 7.(142857)%

1 of 14 equal parts filled — the same share as a bar and as a circle.

Where the decimal comes from

There is no rewrite over 10, 100 or 1000 for 1/14: 14 has a prime factor other than 2 and 5, so no whole-number multiplier reaches a power of ten. Watch the long division to see what happens instead — the remainders start circling, and once a remainder comes back, the digits must too:

  1. 10 ÷ 14 = 0remainder 10
  2. 100 ÷ 14 = 7remainder 2
  3. 20 ÷ 14 = 1remainder 6
  4. 60 ÷ 14 = 4remainder 4
  5. 40 ÷ 14 = 2remainder 12
  6. 120 ÷ 14 = 8remainder 8— …and on it goes; the cycle takes 6 digits to close

Written exactly: 0.0(714285) — the parentheses mark the block that repeats forever.

Every way to write it

Decimal
≈ 0.0714285714
Percent
≈ 7.142857%
Ratio
1 : 14 (part to whole)
As inches
1/14″ = 1.814286 mm

Equivalent fractions

Multiply the top and bottom of 1/14 by the same number and the value does not change:

1/14 = 2/28 = 3/42 = 4/56 = 5/70 = 6/84 · more, or pick a denominator

On the number line

0 1 1/14

As a measurement

Read as inches, 1/14″ is 1.814286 mm exactly. The nearest marks on the finer rules:

RuleNearest markDecimal inchesmmDifference
16ths1/16″ 0.06251.5875−0.2268 mm
32ths1/16″ 0.06251.5875−0.2268 mm
64ths5/64″ 0.0781251.9844+0.1701 mm

Need a different rule or a tolerance? Nearest fraction · Within tolerance

Common questions

What is 1/14 as a decimal?
1/14 is 0.0714285714 rounded; exactly, it is the repeating decimal 0.0(714285).
What is 1/14 as a percentage?
1/14 is about 7.142857% as a percentage.
How many millimetres is 1/14 of an inch?
1/14 of an inch is 1.814286 mm, computed with the exact definition 1 inch = 25.4 mm.

Related

Fraction–decimal chartThe everyday set, printable.Rule charts16ths, 32nds, 64ths, 128ths.The rulerSee 1/14 in its place.
Where this comes from. Exact rational arithmetic on the values shown — fractions are pairs of integers until display, and inch–metric conversion uses 25.4 mm to the inch, exact by definition since 1959. See the full methodology.