5/14

Fraction5/14
Decimal≈ 0.3571428571exactly 0.3(571428)
Percent≈ 35.714286%exactly 35.(714285)%

5 of 14 equal parts filled — the same share as a bar and as a circle.

Where the decimal comes from

There is no rewrite over 10, 100 or 1000 for 5/14: 14 has a prime factor other than 2 and 5, so no whole-number multiplier reaches a power of ten. Watch the long division to see what happens instead — the remainders start circling, and once a remainder comes back, the digits must too:

  1. 50 ÷ 14 = 3remainder 8
  2. 80 ÷ 14 = 5remainder 10
  3. 100 ÷ 14 = 7remainder 2
  4. 20 ÷ 14 = 1remainder 6
  5. 60 ÷ 14 = 4remainder 4
  6. 40 ÷ 14 = 2remainder 12— …and on it goes; the cycle takes 6 digits to close

Written exactly: 0.3(571428) — the parentheses mark the block that repeats forever.

Every way to write it

Decimal
≈ 0.3571428571
Percent
≈ 35.714286%
Ratio
5 : 14 (part to whole)
As inches
5/14″ = 9.071429 mm

Equivalent fractions

Multiply the top and bottom of 5/14 by the same number and the value does not change:

5/14 = 10/28 = 15/42 = 20/56 = 25/70 = 30/84 · more, or pick a denominator

On the number line

0 1 5/14

As a measurement

Read as inches, 5/14″ is 9.071429 mm exactly. The nearest marks on the finer rules:

RuleNearest markDecimal inchesmmDifference
16ths3/8″ 0.3759.525+0.4536 mm
32ths11/32″ 0.343758.7313−0.3402 mm
64ths23/64″ 0.3593759.1281+0.0567 mm

Need a different rule or a tolerance? Nearest fraction · Within tolerance

Common questions

What is 5/14 as a decimal?
5/14 is 0.3571428571 rounded; exactly, it is the repeating decimal 0.3(571428).
What is 5/14 as a percentage?
5/14 is about 35.714286% as a percentage.
How many millimetres is 5/14 of an inch?
5/14 of an inch is 9.071429 mm, computed with the exact definition 1 inch = 25.4 mm.

Related

Fraction–decimal chartThe everyday set, printable.Rule charts16ths, 32nds, 64ths, 128ths.The rulerSee 5/14 in its place.
Where this comes from. Exact rational arithmetic on the values shown — fractions are pairs of integers until display, and inch–metric conversion uses 25.4 mm to the inch, exact by definition since 1959. See the full methodology.